Neff Press Custom Applications

Part Quality Assurance
This system will allow selection of a distance window in which the assembly force will be monitored. A good part or bad part output will be displayed on the operator interface. If a press cycle does not fall into the parameters stored in the controller, the operator will have to acknowledge this before starting a new cycle. READ MORE...

Indexing
Our Mission: Neff's customer required a press that would apply 400 degrees of heat and uniform pressure over a part with a large surface. Complicated by the requirement that the heated surfaces needed to move in order to preheat and to achieve required productivity, this was accomplished by integrating an index unit and robotic pick and place units with a Neff press. Providing the motion to the heated platens was difficult. A further complication was an extremely short cycle time requirement. READ MORE...

Our Mission : To provide several presses to stake studs into automotive brake drums. The application was complicated because of different diameter rotors with varying numbers of studs. A single press will be tasked to stake studs into two different diameter drums, each requiring a different number of studs. READ MORE...

Heated Platen
Our Mission: Neff's customer required a press that would apply 400 degrees of heat and uniform pressure over a part with a large surface. Complicated by the requirement that the heated surfaces needed to move in order to preheat and to achieve required productivity, this was accomplished by integrating an index unit and robotic pick and place units with a Neff press. Providing the motion to the heated platens was difficult. A further complication was an extremely short cycle time requirement. READ MORE...

Our Mission: Our customer, located in New England came to Neff for 2 column presses, each being 150 tons and having bed dimension of 30” (L-R) x 30” (F-B) in between the pins. This customer required the heated platens have a heat up and cool down time of ten minutes, with maximum temperature being 450° F. READ MORE...

Turnkey
Our Mission: Neff recently designed and manufactured a third computerized shaft straightening press for a St. Louis based company in order to eliminate costly manual straightening of casehardened compressor shafts. The shafts are of various diameters and lengths. READ MORE...

Our Mission : To design a system to produce finished parts from strip material. READ MORE...

Explosion-Proof
Our Mission : A long time Neff customer contacted us to duplicate a press we manufactured for them several years ago. The customer, a major automotive airbag manufacturer, required an explosion proof press. During the manufacturing process, the customer uses a highly explosive powder, which acts as the initiator in airbag deployment. Safeguarding the press from these volatile agents is imperative for overall process control. READ MORE...